Nuaire Flatmaster 2000R

The Nuaire Flatmaster 2000R (right exit) is the leading condensation unit for homes without a loft. It is easily installed. It is a very efficient, low maintenance and has very low power consumption.

If your home is suffering from condensation, toxic mould, unwanted pollutants, foul or musty smells then the Flatmaster 2000 can cure these problems in no time at all.

Condensation can cause so many problems within your home and accounts for 70% of reported damp and is also a leading factor causing infestations of the wood boring beetle and dry rot out breaks.

How it works:

Input air is distributed across the ceiling usually in your hallway using a scientific principle known as the Coanda effect, which mixes the warmer air, which is wasted and raised above head height, it therefore circulates the wasted warmer air and increasing the efficiency of the heating system and saving money and energy.

The main benefits of using the Flatmaster 2000 are:

• It uses highly effective G3 filters that are so good they even filter pollen.
• Hugely improves the quality of indoor air.
• Silent like operation.
• Filters only need to be cleaned or replaced once every 1 to 2 years.
• The heater and manual boost switch are all included in the price.
• Extremely low energy consumption.

Why use a Flatmaster 2000 over a normal Dehumidifier?

Dehumidifiers do remove moisture from the air but only in the place of which they are put, this means if it is in a bedroom it will only work on that one effected area but damp is normally all over the home so the other alternative is to have more than one dehumidifier which will incur huge costs so the solution is to use a Flatmaster 2000 which will distribute fresh air throughout the home removing the moisture from the air.

The Flatmaster can be purchased from ASRS Preservations supplies with either a right or left outlet so it can be installed anywhere in the home and exit the home too.

Installations

Installations are normally simple to do and are not very disruptive and can be done quickly. All that our ASRS condensation technicians will need to do is install the Flatmaster near a 100mm entrance hole which the unit sucks air from, then the fresh filtered air will be pushed through the home.